Configuring Static Ipoe Sessions On An Interface - H3C SR8800-F Configuration Manual

•
Disabling ARP-based static individual users do not affect online ARP-based static individual
users.
Procedure
To enable static individual users:
Step
1. Enter system view.
2. Enter interface view.
3. Enable static
individual users.

Configuring static IPoE sessions on an interface

After the configured session information matches a user, the BRAS establishes a static IPoE session
for the user.
On one interface, a maximum of one static IPoE session can be configured for one IP address.
Per-interface static IPoE sessions take precedence over global static IPoE sessions.
To configure a static IPoE session on an interface:
Step
1. Enter system view.
2. Enter interface view.
3. Configure a static
IPoE session.
4. Return to system view.
Command
system-view
interface interface-type
interface-number
•
Enable IPv4 static individual
users:
ip subscriber initiator
unclassified-ip enable
•
Enable IPv4 ARP-based static
individual users:
ip subscriber initiator arp
enable
•
Enable IPv6 static individual
users:
ipv6 subscriber initiator
unclassified-ip enable
Command
system-view
interface interface-type
interface-number
•
Configure a static IPv4 IPoE
session:
ip subscriber session static ip
start-ip-address [ end-ip-address ]
[ vlan vlan-id [ second-vlan
vlan-id ] ] [ mac mac-address ]
[ domain domain-name ]
[ password mac ]
[ request-online ]
•
Configure a static IPv6 IPoE
session:
ipv6 subscriber session static
ipv6 start-ipv6-address
[ end-ipv6-address ] [ vlan vlan-id
[ second-vlan vlan-id ] ] [ mac
mac-address ] [ domain
domain-name ] [ password mac ]
[ request-online]
quit
401
Remarks
N/A
N/A
By default, no static individual user
is enabled.
Remarks
N/A
N/A
By default, no static IPoE session
is configured.
Only subinterfaces support
parameters vlan and
second-vlan.
N/A