Example: Configuring An Arp-Based Static User - H3C SR8800-F Configuration Manual

[Device-radius-rs1] key authentication simple radius
[Device-radius-rs1] key accounting simple radius
# Exclude the ISP name from the username sent to the RADIUS server.
[Device-radius-rs1] user-name-format without-domain
[Device-radius-rs1] quit
d. Configure the ISP domain:
# Create an ISP domain named dm1 and enter its view.
[Device] domain dm1
# Configure dm1 to use RADIUS scheme rs1.
[Device-isp-dm1] authentication ipoe radius-scheme rs1
[Device-isp-dm1] authorization ipoe radius-scheme rs1
[Device-isp-dm1] accounting ipoe radius-scheme rs1
[Device-isp-dm1] quit
e. Configure IPoE:
# Enable IPoE and configure Layer 2 access mode on GigabitEthernet 3/1/2.
[Device] interface gigabitethernet 3/1/2
[Device–GigabitEthernet3/1/2] ipv6 subscriber l2-connected enable
# Enable the IPv6-ND-RS user.
[Device–GigabitEthernet3/1/2] ipv6 subscriber initiator ndrs enable
# Specify dm1 as the ISP domain.
[Device–GigabitEthernet3/1/2] ipv6 subscriber ndrs domain dm1
# Configure plaintext password radius for authentication.
[Device–GigabitEthernet3/1/2] ipv6 subscriber password plaintext radius
[Device–GigabitEthernet3/1/2] quit
Verifying the configuration
# Display IPoE session information to verify that the host has come online.
[Device] display ipv6 subscriber session
Type: D-DHCP
Interface
--------------------------------------------------------------------------------
GE3/1/2

Example: Configuring an ARP-based static user

Network configuration
As shown in
is assigned the gateway IP address 3.3.3.1. The BRAS performs AAA for the host through the
RADIUS server.
Figure 148 Network diagram
S-Static
IP address
10::2c:29ff:fea6:b656
Figure 149, an ARP-based static host accesses the BRAS through a Layer 2 device and
U-Unclassified-IP
MAC address
000c-29a6-b656 N
421
N-NDRS
Type State
Online