Table of Contents
Advertisement
Step
10. (Optional.) Set the response
delay time for user access.
11. Return to system view.
12. Configure the PPPoE server
to perform authentication,
authorization, and
accounting for PPP users.
Setting the maximum number of PPPoE sessions
PPPoE can establish a session when none of the following limits are reached:
•
Limit for a user on an interface.
•
Limit for a VLAN on an interface.
•
Limit on an interface.
•
Limit on a card.
New maximum number settings apply only to subsequently established PPPoE sessions.
To configure the maximum number of PPPoE sessions:
Step
1.
Enter system view.
2.
Enter interface view.
3.
Set the maximum number of
PPPoE sessions on an
interface.
4.
Set the maximum number of
PPPoE sessions for a VLAN
on an interface.
5.
Set the maximum number of
PPPoE sessions for a user
on an interface.
6.
Return to system view.
7.
(In standalone mode.) Set
the maximum number of
PPPoE sessions on the
specified card.
8.
(In IRF mode.) Set the
maximum number of PPPoE
sessions on a card of an IRF
member device.
Limiting the PPPoE access rate
The device can limit the rate at which a user (identified by an MAC address) can create PPPoE
sessions on an interface. If the number of PPPoE requests within the monitoring time exceeds the
configured threshold, the device discards the excessive requests, and outputs log messages. If the
blocking time is set to 0, the device does not block any requests, and it only outputs log messages.
Command
pppoe-server access-delay
delay-time
quit
See
"Configuring
AAA."
Command
system-view
interface interface-type
interface-number
pppoe-server session-limit
number
pppoe-server session-limit
per-vlan number
pppoe-server session-limit
per-mac number
quit
pppoe-server session-limit slot
slot-number total number
pppoe-server session-limit
chassis chassis-number slot
slot-number total number
278
Remarks
By default, no response delay
time is set.
N/A
N/A
Remarks
N/A
The PPPoE server is enabled on
the interface.
By default, the number of PPPoE
sessions on an interface is not
limited.
By default, the number of PPPoE
sessions for a VLAN on an
interface is not limited.
By default, a user is allowed to
create a maximum of one PPPoE
session.
N/A
By default, the number of PPPoE
sessions on a card is not limited.
By default, the number of PPPoE
sessions on a card is not limited.
Advertisement
Table of Contents
Troubleshooting
