Configuring Accounting Methods For An Isp Domain - H3C SR8800-F Configuration Manual

Step
9. Specify authorization
methods for PPP users.

Configuring accounting methods for an ISP domain

Restrictions and guidelines
When configuring accounting methods, follow these guidelines:
•
FTP, SFTP, and SCP users do not support accounting.
•
Local accounting does not provide statistics for charging. It only counts and controls the number
of concurrent users that use the same local user account. The threshold is configured by using
the access-limit command.
When the primary accounting method is local, the following rules apply to the accounting of a user:
•
The device uses the backup accounting methods in sequence only if local accounting is invalid
for one of the following reasons:
An exception occurs in the AAA process.
The user disconnects from the device.
The user account is not configured on the device or the user is not allowed to use the
access service.
•
The device does not turn to the backup accounting methods if local accounting is invalid
because of any other reason. Accounting fails for the user.
Prerequisites
Before configuring accounting methods, complete the following tasks:
1. Determine the access type or service type to be configured. With AAA, you can configure an
accounting method for each access type and service type.
2. Determine whether to configure the default accounting method for all access types or service
types. The default accounting method applies to all access users. However, the method has a
lower priority than the accounting method that is specified for an access type or service type.
Procedure
To configure accounting methods for an ISP domain:
Step
1. Enter system view.
2. Enter ISP domain view.
Command
authorization ppp { hwtacacs-scheme
hwtacacs-scheme-name
[ radius-scheme radius-scheme-name ]
[ local ] [ none ] | local [ radius-scheme
radius-scheme-name |
hwtacacs-scheme
hwtacacs-scheme-name ] * [ none ] |
none | radius-scheme
radius-scheme-name
[ hwtacacs-scheme
hwtacacs-scheme-name ] [ local ]
[ none ] }
Command
system-view
domain isp-name
62
Remarks
By default, the default
authorization method is used
for PPP users.
Remarks
N/A
N/A