Enabling Pppoe Logging; Display And Maintenance Commands For Pppoe - H3C SR8800-F Configuration Manual

Enabling MAC-based user blocking in system view
Step
1. Enter system view.
2. Enable MAC-based user
blocking.
Enabling MAC-based user blocking in interface view
Step
1. Enter system view.
2. Enter interface view.
3. Enable MAC-based user
blocking.

Enabling PPPoE logging

The PPPoE logging feature enables the device to generate PPPoE logs and send them to the
information center. Logs are generated when the following requirements are met:
•
The number of PPPoE sessions reaches the upper limit for an interface, user, VLAN, or the
system.
•
New users request to come online.
A log entry records the interface-based, MAC-based, VLAN-based, or system-based session limit.
For information about the log destination and output rule configuration in the information center, see
Network Management and Monitoring Configuration Guide.
As a best practice, disable this feature to prevent excessive PPP log output.
To enable PPPoE logging:
Step
1. Enter system view.
2. Enable PPPoE logging.

Display and maintenance commands for PPPoE

Execute display commands in any view and reset commands in user view.
Task
(In standalone mode.) Display PPPoE chasten
statistics.
Command
system-view
pppoe-server connection
chasten [ quickoffline ]
[ multi-sessions-permac ]
requests request-period
blocking-period
Command
system-view
interface interface-type
interface-number
pppoe-server connection
chasten [ quickoffline ]
[ multi-sessions-permac ]
requests request-period
blocking-period
Command
system-view
pppoe-server log enable
Command
display pppoe-server chasten statistics
[ mac-address ] [ interface interface-type
interface-number | slot slot-number ]
282
Remarks
N/A
By default, MAC-based user
blocking is disabled.
Remarks
N/A
The PPPoE server is enabled on
the interface.
By default, MAC-based user
blocking is disabled.
Remarks
N/A
By default, PPPoE logging is
disabled.