Example: Configuring Dynamic Ip Address Assignment - H3C SR8800-F Configuration Manual

[RouterA-GigabitEthernet1/0/1] ip address 10.1.1.1 25
[RouterA-GigabitEthernet1/0/1] quit
2. Configure the DHCP server:
# Enable DHCP.
[RouterA] dhcp enable
# Enable the DHCP server on GigabitEthernet 1/0/1.
[RouterA] interface gigabitethernet 1/0/1
[RouterA-GigabitEthernet1/0/1] dhcp select server
[RouterA-GigabitEthernet1/0/1] quit
# Create DHCP address pool 0.
[RouterA] dhcp server ip-pool 0
# Configure a static binding for Router B.
[RouterA-dhcp-pool-0] static-bind ip-address 10.1.1.5 25 client-identifier
0030-3030-662e-6532-3030-2e30-3030-322d-4574-6865-726e-6574
# Configure a static binding for Router C.
[RouterA-dhcp-pool-0] static-bind ip-address 10.1.1.6 25 hardware-address
000f-e200-01c0
# Specify the DNS server address and the gateway address.
[RouterA-dhcp-pool-0] dns-list 10.1.1.2
[RouterA-dhcp-pool-0] gateway-list 10.1.1.126
[RouterA-dhcp-pool-0] quit
[RouterA]
Verifying the configuration
# Verify that Router B can obtain IP address 10.1.1.5 and all other network parameters from Router A.
(Details not shown.)
# Verify that Router C can obtain IP address 10.1.1.6 and all other network parameters from Router
A. (Details not shown.)
# On the DHCP server, display the IP addresses assigned to the clients.
[RouterA] display dhcp server ip-in-use
IP address
10.1.1.5
10.1.1.6

Example: Configuring dynamic IP address assignment

Network configuration
As shown in
10.1.1.0/24, which is subnetted into 10.1.1.0/25 and 10.1.1.128/25.
Configure DHCP server on Router A to implement the following assignment scheme.
Client identifier/
Hardware address
0030-3030-662e-6532-
3030-2e30-3030-322d-
4574-6865-726e-6574
000f-e200-01c0
Figure 33, the DHCP server (Router A) assigns IP addresses to clients on subnet
Lease expiration
Jan 21 14:27:27 2014
Unlimited
121
Type
Static(C)
Static(C)