7.3.3
Replacing the Pressure Roller
You can easily remove and replace a damaged or worn pressure roller.
1
Make sure that the product is in power off
mode, then disconnect the power cord
from the AC outlet.
2
Open the top cover.
CAUTION
Open the top cover fully to prevent accidental drop of
the cover.
3
Turn the head lock lever clockwise to
unlock the print head.
CAUTION
• The print head and its surroundings are hot after
printing. Be careful not to touch it, to avoid being
burned.
• Touching the edge of the print head with your bare
hand could cause injury.
4
Push the pressure roller release tab
up to release the pressure roller plate
.
5
Loosen the screw until the bearing
clamp is released.
Do not remove the screw.
6
Remove the bearing from the chassis
and the shaft of the pressure roller .
7
Pull out the pressure roller from the
product and replace it with a new
pressure roller.
4
2
5
S84-ex/S86-ex Operator Manual
7 Maintenance
1
7
6
3
295