SATO S84-ex Operator's Manual page 394

9 Appendix
Item
Label feed
Head check
External signal
PRIN
PREND(TYPE1)
PREND(TYPE2)
PREND(TYPE3)
PREND(TYPE4)
Operation
Home position
(3 pin)
Dispenser input
(9 pin)
392
S84-ex/S86-ex Operator Manual
Power ON
*1
20 ms
Print 1st label
Waiting time until product recognizes PRIN signal
*1 Maintain PRIN signal until PREND signal is output.
When the label is removed from the dispense area,
the Dispenser Input is initiated by the applicator.
Input Waveform
After Dispenser input becomes High, backfeed starts
20 ms
*1
Backfeed
When backfeed is complete, Home position goes Low
until the Print Start is initiated and then it goes back High.
*When the product is set to Dispenser Input Mode
it should backfeed upon recieving Print Start
no matter the Dispense Input has been triggered or not.
Backfeed
Print 2nd label