More About The Media Stop Position - SATO S84-ex Operator's Manual

6 Adjusting the Product
Adjust the stop position using the following procedure:
1
Make sure that the product is in online mode or offline mode.
2
Press the
to enter the adjustment mode.
PITCH POSITION shows on the screen.
3
Press the
next adjustment screen.
OFFSET POSITION shows on the screen.
4
Change the setting value. Press the
buttons to set the desired value.
Set the offset value with '+' to move the stop
position opposite the feed direction, and value
with '-' to move the stop position in the feed
direction.
The setting value is adjustable by 0.25 mm (0.01")
regardless of the print resolution.
The setting range is from -3.75 mm (-0.15") to
+3.75 mm (+0.15").
5
Press the
setting and proceed to the next
adjustment screen.
6.1.4

More about the Media Stop Position

Stop position of the label in dispenser
mode.
The regular position is to let the label stay about 1
mm (0.04") on the liner.
264
S84-ex/S86-ex Operator Manual
and buttons for one second
ENTER button to go to the
ENTER button to save the
/
Stop
position