SATO S84-ex Operator's Manual page 194

4 Operation and Configuration
LABEL LENGTH
Set the length of the test print.
The setting range is from 50 mm to 200 mm and is adjustable by 10 mm.
Note
Shows only if TEST PRINT MODE is set to CONFIGURE LIST.
PITCH POSITION/OFFSET POSITION/DARKNESS
Adjust the print position, offset position and print darkness.
The setting range for both PITCH POSITION and OFFSET POSITION is
±3.75 mm (±0.15") and is adjustable by 0.25 mm (0.01").
The setting range for DARKNESS is from 00 to 99.
Note
Press the ENTER button to start the test print.
TEST PRINT PRESS ENTER KEY
The test print is in progress.
Press the ENTER button while printing to pause the test print
operation. Press the
192
S84-ex/S86-ex Operator Manual
ENTER button again to continue.