Installing The Product Onto A Support Structure/Applicator - SATO S84-ex Operator's Manual
Hide thumbs
Also See for S84-ex:
- Programming reference manual (452 pages) ,
- Operator's manual (380 pages) ,
- Configuration manual (2 pages)
Table of Contents
Advertisement
2 Installing the Product
2.3 Installing the Product onto a Support
Structure/Applicator
This product must be installed onto a support structure/applicator for correct operation.
The product has five bores on the center frame for installing to a support structure.
Attach five bolts to the five bores on the center frame to install the product onto the support structure.
WARNING
Make sure that you use the designated bolts that can accommodate the weight of the product.
If you do not install the product correctly, it could fall out of the support structure. This may cause injury.
The picture below shows the installation of the product onto the support structure.
Note
This picture is for an instructional display purpose only and is not to be interpreted as a precise example.
31
S84-ex/S86-ex Operator Manual
Advertisement
Table of Contents
Troubleshooting
