7 Maintenance
8
Insert the gear end of the new media
feed roller fully into the center frame
of the product.
9
Place the bearing back to the chassis
and the shaft of the media feed roller.
10
Rotate the bearing clamp onto the
bearing and attach it with the screw
.
7.3.5
Replacing the Fan Filter
The fan filter prevents atmospheric debris from being drawn into the product.
1
Peel off the old fan filter from the rear
of the product.
2
Clean the product to remove any
adhesive residue on the surface.
Note
You can purchase a cleaning kit from a SATO reseller
or technical service center.
3
Remove the backing paper from the new
fan filter and paste the fan filter
over the fan exhaust holes.
298
S84-ex/S86-ex Operator Manual
6
4
7
5
1