Mapping Input Power From Ac Power Distribution Modules To Ac Power Supply Modules On Mx2000 Routers - Juniper MX2020 Hardware Manual

15. Use the provided plastic cable tie to fasten the AC power cord to the PDM.
16. Verify that the AC power cord does not touch or block access to router components, and that it does
not drape where people could trip on it.
17. Repeat the procedure for the other three-phase wye AC PDMs.
RELATED DOCUMENTATION
MX2000 Three-Phase Wye AC Power Distribution Module Description | 98
MX2000 Three-Phase Delta AC Power Distribution Module Description | 96
MX2000 Three-Phase Delta and Wye AC Power Distribution Module LEDs | 103
Powering On a Three-Phase AC-Powered MX2000 Router | 331
MX2000 AC Power System Electrical Specifications | 179
MX2000 AC Power Cord Specifications | 176
Prevention of Electrostatic Discharge Damage | 770
Mapping Input Power from AC Power Distribution Modules to AC Power
Supply Modules on MX2000 Routers
You connect AC power to the router by connecting two AC power cords to each AC PDM. One feed maps
to six PSMs and the other maps to three PSMs.
and Figure 73 on page 191
components of the PDM.
and PDM1/Input1 (MX2010 and MX2020).
AC PDM2/Input0 and PDM3/Input1 (MX2020 only).
Figure 72 on page 191
shows the mapping for the MX2020. The arrangement matches the internal
Table 68 on page 192 shows the AC PDM input mapping to AC PDM0/Input0
Table 69 on page 192
shows the mapping for the MX2010
shows the AC PDM input mapping to
304