Installing The Pallet Jack Attachment - Juniper MX2020 Hardware Manual

Installing the Pallet Jack Attachment

To install the pallet jack attachment to the pallet jack:
1. Remove the pallet jack attachment from the shipping crate.
2. Place the pallet jack attachment across both pallet jack legs.
3. Using a 9/16-in. (14 mm) socket wrench, loosen and remove the eight shipping bracket support torque
fasteners that are located on the top of the pallet jack attachment platform.
4. Using a 9/16-in. (14 mm) socket wrench, loosen the torque fasteners that are located on the four
adjustable pallet jack attachment brackets.
5. Adjust the four pallet jack attachment brackets until they fit under the pallet jack legs.
6. Tighten the torque fasteners by using a 9/16-in. (14 mm) socket wrench to secure the brackets on the
pallet jack attachment to the pallet jack (see
Figure 99: Installing Pallet Jack Attachment onto Pallet Jack
Figure 99 on page 259).
259