Juniper MX2020 Hardware Manual page 552

534
2. Place one hand around the MPC faceplate about a quarter of the way down from the top edge. To
avoid deforming the EMI shielding strip, do not press hard on it.
3. Place your other hand at the bottom edge of the MPC.
If the MPC is horizontal before you grasp it, place your left hand around the faceplate and your right hand
along the bottom edge.
To hold an MPC horizontally:
1. Orient the MPC so that the faceplate faces you.
2. Grasp the top edge with your left hand and the bottom edge with your right hand.
You can rest the faceplate of the MPC against your body as you carry it.
As you carry the MPC, do not bump it against anything. MPC components are fragile.
Never hold or grasp the MPC anywhere except places that this document indicates. In particular, never
grasp the connector edge, especially at the power connector in the corner where the connector and bottom
edges meet.
Figure 234: Do Not Grasp the Connector Edge
Never carry the MPC by the faceplate with only one hand.
Do not rest any edge of an MPC directly against a hard surface (see Figure 235 on page 535).
Do not stack MPCs.