Removing The Mx2020 Upper Cable Manager - Juniper MX2020 Hardware Manual

Figure 282: Installing the Standard Lower Cable Manager
RELATED DOCUMENTATION
Removing the MX2020 Lower Cable Manager | 618

Removing the MX2020 Upper Cable Manager

NOTE: To accommodate additional clearance, you may order an extended upper cable manager
from Juniper Networks.
To remove the upper cable manager (see
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Loosen the two captive screws on the upper cable manager cover, and remove it.
3. Using a Phillips (+) screwdriver (number 1 or 2), loosen the mounting screws on the upper cable manager.
4. Grasp the upper cable manager, and pull it straight out from the studs on the front of the chassis.
Figure 269 on page 618):
631