Mx2020 Chassis Moving Guidelines - Juniper MX2020 Hardware Manual

NOTE: Additional grounding is provided to an AC-powered router when you plug its PDMs into
grounded AC power receptacles.
WARNING:
protective earthing terminal (Metric [–M6] and Standard [–¼-20] screw ground lugs)
provided on the chassis in addition to the grounding pin of the power supply cord. This
separate protective earth terminal must be permanently connected to earth.
RELATED DOCUMENTATION
Grounding an MX2000 Router | 291
Tools and Parts Required for Connecting an MX2000 Router to Power | 224

MX2020 Chassis Moving Guidelines

The fully configured chassis with the cable managers weighs up to 1,515 lb (687.19 kg), or 429.6 lb
(194.86 kg) with components removed. Observe the following guidelines for moving the router:
Before moving the router, read the
to verify that the intended site meets the specified power, environmental, and clearance requirements.
Do not attempt to move a fully configured router by yourself. Using a pallet jack with attachment and
a four person team to maneuver the router into a rack is recommended.
Before moving the router, disconnect all external cables.
To move routing devices and components, use the following guidelines:
1 person to lift or move up to 39.7 lb (18.0 kg)
2 people to lift or move up to 70.5 lb (32.0 kg)
3 people to lift or move up to 220 lb (99.8 kg)
4 people to lift or move over 300 lb (136.0 kg)
As when moving any heavy object, lift most of the weight with your legs rather than your back. Keep
your knees bent and your back relatively straight and avoid twisting your body as you lift. Balance the
load evenly and be sure that your footing is solid.
The router is installed in a restricted-access location. It has a separate
"Overview of Preparing the Site for the MX2020 Router" on page 121
141