Juniper MX2020 Hardware Manual page 365

3. Insert the cable connector into the cable connector port on the faceplate.
4. Arrange the cable in the cable manager to prevent it from dislodging or developing stress points. Secure
the cable so that it is not supporting its own weight as it hangs to the floor. Place excess cable out of
the way in a neatly coiled loop. Placing fasteners on the loop helps to maintain its shape.
CAUTION:
An arc smaller than a few inches in diameter can damage the cable and cause
problems that are difficult to diagnose.
CAUTION:
allow fastened loops of cable to dangle, which stresses the cable at the fastening
point.
Figure 160: Attaching a Cable to a MPC
0
10
11
12
13
14
15
16
17
18
19
Avoid bending fiber-optic cable beyond its minimum bend radius.
Do not let fiber-optic cable hang free from the connector. Do not
345