Juniper MX2020 Hardware Manual page 289

3. Using a two person team on either side of the chassis, turn the handles on the router transport 4-5
times until the chassis is raised approximately 1 in. (2.54 cm), making sure that the chassis is level.
NOTE: The router transport kit is equipped with four T-shaped levels on top of each of
the four router transport mounting brackets. Make sure the bubbles within the T-shaped
levels are between the lines, indicating the chassis is level.
CAUTION:
router will not tilt when transporting, which can result in injury or damage to
the router.
4. Turn the four wheels on the router transport kit toward the rear of the chassis.
5. Grasping the handles on the shipping covers, carefully guide the chassis down the crate ramp to the
rack location.
WARNING:
excessive speed can cause the wheels to turn abruptly and tilt the router over.
CAUTION:
these handles only to help position the router.
6. Position the router transport platform directly under the router, aligning the router transport platform
with the bottom of the chassis by adjusting the four leveling mounts.
NOTE: The router transport platform height can be adjusted between 0.25 in. (0.6 cm)
to a maximum of 4 in. (10.16 cm).
7. Secure the router transport platform to the router transport mounting plates using the four latch locks
(see Figure 106 on page
Do not raise the chassis above 1 in. (2.54 cm). This will ensure the
Do not push or pull the router fast during transporting. Using
Do not lift the router using the handles on the shipping covers. Use
270).
269