Verifying And Configuring The Upgraded Cb-Re - Juniper MX2020 Hardware Manual

If the OK/FAIL LED is yellow, remove and install the CB-RE again. If the OK/FAIL LED still lights
steadily, the CB-RE is not functioning properly. Contact your customer support representative. See
"Contacting Customer Support" on page
7. Check the status of the CB-RE by using the show chassis environment cb command.
Figure 232: Installing a CB-RE
The CB-RE might require several minutes to boot. After the CB-RE boots, verify that it is installed correctly
by checking the FAIL, RE0, and RE1 LEDs on the craft interface. If the router is operational and the CB-RE
is functioning properly, the green ONLINE LED on the CB-RE lights steadily. If the red FAIL LED lights
steadily instead, remove the CB-RE and reinstall it. If the red FAIL LED on the CB-RE still lights steadily,
the CB-RE is not functioning properly. Contact your customer support representative.

Verifying and Configuring the Upgraded CB-RE

After replacing the CB-RE with the REMX2K-X8-64G CB-RE, perform the following steps:
1. Verify that the REMX2K-X8-64G CB-RE is online by issuing the show chassis hardware and show
chassis routing-engine |no-more commands.
Verify the software by using the show vmhost status and show vmhost version commands.
2. After you install the REMX2K-X8-64G CB-RE, the CB-RE gets automatically powered on and comes
up in amnesiac mode as it is loaded with factory defaults. After the CB-RE comes up in amnesiac mode,
load the base configuration and commit.
705.
519