Mx2020 Dc And Power Supply Module Leds - Juniper MX2020 Hardware Manual

Installing the MX2020 Air Filters | 459
Removing the MX2020 Air Filters | 456

MX2020 DC and Power Supply Module LEDs

Each DC PSM (-48 V and 240 V China) faceplate contains four LEDs. These LEDs are described in
Table 34 on page 117. Eighteen bicolor LEDs labeled 0 through 8 for the bottom nine PSMs, and 9 through
17 for the top nine PSMs, are located in the center of the craft interface.
The primary input of the PSM is a dual redundant feed, INP0 and INP1. Both feeds are active during
operation, but both feeds may or may not be providing current. In addition, a PSM failure triggers the alarm
LED on the craft interface.
Table 34: MX2020 DC Power Supply Module LEDs
Label Color
PWR OK Green
Yellow
–
FAULT Red
–
INP0 Green
Yellow
–
INP1 Green
Yellow
–
RELATED DOCUMENTATION
State Description
On PSM is functioning normally with no alarms.
On PSM controller is functioning normally.
Off PSM is not functioning normally or the PSM controller is off.
On PSM is not functioning normally or the DC input voltage of one or more
feeds is out of range.
Off PSM is functioning normally or both the DIP switches are set to off.
On DC input is within required voltage range and the DIP switch is set to on.
On DC input is detected but voltage is out of range.
Off DC input to the PSM is not present.
On DC input is within required voltage range and the DIP switch is set to on.
On DC input is detected but voltage is out of range.
Off DC input to the PSM is not present.
117