Installing An Mx2000 Sfb - Juniper MX2020 Hardware Manual

SEE ALSO
Maintaining the MX2010 SFB

Installing an MX2000 SFB | 492

Installing an MX2000 SFB
To install an SFB (see Figure 225 on page
CAUTION:
stored horizontally and pressed toward the center of the SFB.
CAUTION:
replacement or blank panel to install.
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Take each SFB to be installed out of its electrostatic bag, and identify the slot on the SFB where it will
be connected.
3. Carefully align the sides of the SFB with the guides inside the chassis.
4. Slide the SFB into the chassis until you feel resistance, carefully ensuring that it is correctly aligned.
5. Place the ejector handles in their proper position, vertically and toward the center of the board.
493):
Before removing or replacing an SFB, ensure that the ejector handles are
If one of the SFBs fails, do not remove the failed SFB until you have a
492