Installing An Mx2020 Dual-Wide Mic - Juniper MX2020 Hardware Manual

6. Close the ejector handle of the transceiver.
7. Remove the rubber safety cap from the transceiver and the end of the cable. Insert the cable into the
transceiver.
WARNING:
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable connected
to a transceiver emit laser light that can damage your eyes.
8. Verify that the status LEDs on the component faceplate indicate that the SFP or XFP is functioning
correctly. For more information about the component LEDs, see the
RELATED DOCUMENTATION
Removing an SFP or XFP from an MX2010 MPC or MIC
Removing an SFP or XFP Transceiver from an MX2020 MPC or MIC | 565
Prevention of Electrostatic Discharge Damage | 770

Installing an MX2020 Dual-Wide MIC

To install a dual-wide MIC:
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Remove the septum, if necessary (see
a. Place the MPC on a flat surface. If necessary, remove the MPC from the ADC as described in
"Removing an MX2020 MPC from the Adapter Card" on page
b. Remove the four screws labeled S on the bottom of the MPC.
c. Remove the two screws labeled S on the top of the MPC.
d. Slide the septum toward you and out of the MPC.
Do not look directly into a fiber-optic transceiver or into the ends
Figure 244 on page
MX Series Interface Module
559):
539.
569
Reference.