Juniper MX2020 Hardware Manual page 627

CAUTION:
An arc smaller than a few inches in diameter can damage the cable and cause
problems that are difficult to diagnose.
CAUTION:
allow fastened loops of cable to dangle, which stresses the cable at the fastening
point.
5. Insert the other end of the cable into the destination port.
6. Repeat the previous steps for any additional cables.
7. If the component is offline (its failure indicator LED is lit), use one of the following methods to bring it
online.
To bring an MPC online:
Press and hold the corresponding online button on the craft interface until the green OK LED next
to the button lights steadily, in about 5 seconds.
Issue the following CLI command:
user@host>request chassis fpc slot slot-number online
For more information about the command, see the
Reference.
NOTE:
power, and the system total power will decrease.
To bring a MIC online:
Press the MIC offline/online button until the MIC LED lights green.
Issue the following CLI command:
user@host>request chassis mic fpc-slot fpc-slot mic-slot mic-slot online
For more information about the command, see the
Reference.
Avoid bending fiber-optic cable beyond its minimum bend radius.
Do not let fiber-optic cable hang free from the connector. Do not
When issuing the request chassis fpc online command, the FRU will get
Junos OS System Basics and Services Command
Junos OS System Basics and Services Command
611