Table of Contents
Advertisement
Powering on and configuring the storage
system
After all enclosures are installed and properly connected, use the MGMT port to perform the following
configuration steps.
•
Setting the initial network configuration on page 41
•
Powering on the storage system on page 41
•
Using the Configuration Setup for initial storage system settings on page 42
•
Completing Configuration Setup on page 48
Setting the initial network configuration
Procedure
1. Connect an Ethernet cable from an administrative computer to the MGMT port on the storage
controller in slot 1 of the array enclosure.
2. Configure the administrative computer as follows:
a. Use 172.16.253.205 as the IP address.
b. Use a subnet mask of 255.255.255.248.
c. Do not use a default gateway.
Powering on the storage system
NOTE:
There is no power switch on the enclosure. Power is applied to the enclosure immediately when
connected to a live power source.
Procedure
1. Connect a power cord from the power source to each drive enclosure.
IMPORTANT:
The best practice is to power on the drive enclosures before the array enclosure. This order
ensures that all disk drives have spun up and that all storage is discovered.
2. Connect a power cord from the power source to the array enclosure.
3. Wait a few minutes for all the components to complete their power-on self test routines, then verify the
system operating status by checking the LED displays. For more information on interpreting the LED
displays, see Status LED descriptions.
Powering on and configuring the storage system
41
Advertisement
Table of Contents
Need help?
Do you have a question about the StoreVirtual 3200 and is the answer not in the manual?