Step 4 Select the parameters of the PTZ camera from the drop-down list.
Note:
All the parameters should be exactly the same as the PTZ camera parameters.
For the Coaxitron camera/dome connected, you can select the PTZ protocol to UTC
(Coaxitron). Make sure the protocol selected here is supported by the connected
camera/dome.
When the Coaxitron protocol is selected, all the other parameters like the baud rate,
data bit, stop bit, parity and flow control are not configurable.
Step 5 (Optional) Click Copy button to copy the settings to the other channels. Select the
channels you want to copy to and click OK to return to the PTZ Parameters
Settings interface.
Step 6 Click OK to save the settings.
Step 7 (Optional) Check the checkbox of Enable Omnicast Control to enable the PTZ
control of the selected camera via Omnicast VMS of Genetec.
4.2 Setting PTZ Presets, Patrols and Patterns
Before you start
Please make sure that the presets, patrols and patterns should be supported by PTZ
protocols.
Copy to Other Channels
60