Network Settings; Configuring The General Settings - Grundig GD-RT-AC3016N User Manual

12. Network Settings

12.1 Configuring the General Settings

Network settings must be properly configured before you operate DVR over network.
Step 1 Go to Menu > Configuration > Network > General.
Step 2 On the General Settings interface, you can configure the following parameters:
Working Mode (applicable for GD-RT-AT5016N), NIC Type, IPv4 Address, IPv4
Gateway, MTU, DNS Server and Main NIC.
Working Mode
There are two 10M/100M/1000M NIC cards provided by GD-RT-AT5016N, and it
allows the device to work in Multi-address and Net-fault Tolerance.
 Multi-address Mode: The parameters of the two NIC cards can be configured
independently. You can select LAN1 or LAN2 in the NIC type field for parameter
settings.
You can select one NIC card as default route. And then the system is connecting
with the extranet and the data will be forwarded through the default route.
 Net-fault Tolerance Mode: The two NIC cards use the same IP address, and you
can select the Main NIC to LAN1 or LAN2. By this way, in case of one NIC card
failure, the device will automatically enable the other standby NIC card so as to
ensure the normal running of the whole system.
Note:
Network Settings Interface
152