Step 7 Click
and draw a quadrilateral in the preview window by specifying four vertexes
of the detection region, and right click to complete drawing. Only one region can be
configured.
You can use the
Note:
Up to 4 rules can be configured.
Step 8 Click Apply to save the settings.
10.6 Region Exiting Detection
This function may not be available in each recorder model.
Region exiting detection function detects people, vehicle or other objects which exit from a
pre-defined virtual region, and some certain actions can be taken when the alarm is
triggered.
Note:
Please refer to the Chapter 9.5 Region Entrance Detection for operating steps to
configure the region exiting detection.
Up to 4 rules can be configured.
10.7 Loitering Detection
This function may not be available in each recorder model.
Loitering detection function detects people, vehicle or other objects which loiter in a
pre-defined virtual region for some certain time, and a series of actions can be taken when
the alarm is triggered.
Note:
Please refer to the Chapter 9.4 Intrusion Detection for operating steps to configure
the loitering detection.
The Threshold [1s-10s] in the Rule Settings defines the time of the object loitering in
the region. If you set the value as 5, alarm is triggered after the object loitering in the
region for 5s; and if you set the value as 0, alarm is triggered immediately after the
object entering the region.
Up to 4 rules can be configured.
to clear the existing virtual line and re-draw it.
142