Table of Contents
Advertisement
If you specify the mfr keyword without any MFR interface number, this command displays information
about all MFR interfaces.
Examples
# Display the configuration and status information about interface MFR 3/1/1.
<Sysname> display interface MFR 3/1/1
MFR3/1/1 current state: UP
Line protocol current state: UP
Description: MFR3/1/1 Interface
The Maximum Transmit Unit is 1500, Hold timer is 10(sec)
Internet Address is 10.0.35.1/24 Primary
Link layer protocol is FR IETF
LMI DLCI is 0, LMI type is Q.933a, frame relay DCE
LMI status enquiry received 452, LMI status sent 452
LMI status enquiry timeout 0, LMI message discarded 0
Physical is MFR, baudrate: 4096000 bps
Last clearing of counters:
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
2263 packets input, 26840 bytes, 0 drops
113305 packets output, 12908653 bytes, 0 drops
# Display brief information about interface MFR 3/1/1.
<Sysname> display interface MFR 3/1/1 brief
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface
MFR4
# Display the brief information of all MFR interfaces in the DOWN state.
<Sysname> display interface MFR brief down
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Interface
MFR1
Table 17 Output description
Field
MFR3/1/1 current state : UP
Never
Link Protocol Main IP
UP
UP(s)
--
Link Cause
DOWN Not connected
83
Description
Description
Physical layer state of the MFR interface, which can
be:
•
DOWN (Administratively)—Indicates that the
interface has been shut down with the shutdown
command.
•
DOWN—Indicates that the interface is physically
down but administratively up.
•
UP—Indicates that the interface is both
administratively and physically up.
Advertisement
Table of Contents
