Table of Contents
Advertisement
Field
Line protocol current state : UP
Description : MFR3/1/1 Interface
The Maximum Transmit Unit is 1500
Hold timer is 10(sec)
Internet Address is 10.0.35.1/24 Primary
link-protocol is FR IETF
LMI DLCI is 0, LMI type is Q.933a, frame relay DCE
LMI status enquiry received 452, LMI status sent 452
LMI status timeout 0, LMI message discarded 0
Physical is MFR
baudrate
Last clearing of counters
Last 300 seconds input rate
Last 300 seconds output rate
2263 packets input, 26840 bytes, 0 drops
113305 packets output, 12908653 bytes, 0 drops
The brief information of interface(s) under route mode
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface
Description
Link layer state of the MFR interface, which can be:
•
DOWN—Indicates that the link layer of the
interface is down.
•
UP—Indicates that the link layer of the interface is
up.
Interface description.
MTU.
Value of the T391 parameter at the DTE side, in
seconds.
IP address and mask.
Link layer protocol.
DLCI number used by LMI, LMI type, port type and
operating mode.
The number of transmitted LMI Status-Enquiry
messages and that of the received LMI Status
messages.
The number of LMI Status messages that timed out and
the number of dropped LMI messages.
Physical interface is MFR.
Baudrate of the MFR interface.
Time when the interface statistics were last cleared
The output Never indicates that the interface statistics
have never been cleared.
Input rate of the interface within the last five minutes.
Output rate of the interface within the last five minutes.
Number of packets and bytes received on the
interface and packets dropped as the result of full
receive buffer.
Number of packets and bytes transmitted on the
interface and packets dropped as the result of full
transmit buffer.
Brief information about Layer 3 interfaces.
Link status:
•
ADM—The interface has been administratively
shut down. To recover its physical state, perform
the undo shutdown command.
•
Stby—The interface is operating as a backup
interface.
If the network layer protocol state of an interface is
shown as UP, but its link is an on-demand link or not
present at all, its protocol attribute includes the
spoofing flag (an s in parentheses).
Abbreviated interface name.
84
Advertisement
Table of Contents
