Table of Contents
Advertisement
View
Any view
Default level
1: Monitor level
Parameters
interface-number: Specifies the number of an ATM main interface.
subnumber: Specifies the number of an ATM subinterface, in the range of 0 to 1023. It is separated from
the main interface by a dot (.).
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Description
Use the display interface atm command to display the configuration and state information of the
specified ATM interface or all ATM interfaces if no interface is specified.
Examples
# Display the configuration and state information of interface ATM 4/1/2.
<Sysname> display interface Atm 4/1/2
Atm4/1/2 current state: UP
Line protocol current state: UP
Description: Atm4/1/2 Interface
The Maximum Transmit Unit is 1200
Internet protocol processing : disabled
AAL enabled: AAL5, Maximum VCs: 1024
Current VCs: 100 (0 on main interface)
Current VPs: 0 (0 on main interface)
Port connector type is OC3/STM_1_SR_SFP
Physical layer is packet over SDH
Port speed type: STM-1
Loopback is not set
Clock source: Slave
Clock grade: Quality unknown(existing synchronization network)
SPE scrambling: Enable
BER thresholds:
SD: 10e-6
Regenerator section layer:
J0(TX): "h3c"
J0(RX): "h3c"
Alarm: NONE
SF: 10e-3
68 33 63 00 00 00 00 00 00 00 00 00 00 00 00 00
68 33 63 00 00 00 00 00 00 00 00 00 00 00 00 00
8
Advertisement
Table of Contents
