H3C SR8800 Command Reference Manual page 47

MP12
# Display brief information about all MP-group interfaces in the DOWN state.
<Sysname> display interface Mp-group brief down
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Interface
MP2/1/13
MP3/1/1
Table 7 Output description
Field
current state
Line protocol current state
Description
The Maximum Transmit Unit
Hold timer
Internet Address is 5.1.0.1/24 Primary
LCP opened, MP opened, IPCP opened
Physical is MP, baudrate
Last clearing of counters
Last 300 seconds input rate
Last 300 seconds output rate
594447 packets input, 11254154 bytes, 0
drops
579254 packets output, 9807856 bytes, 0
drops
The brief information of interface(s) under route
mode
Link: ADM - administratively down; Stby - standby
DOWN DOWN --
Link Cause
ADM Administratively
DOWN Not connected
39
Description
Physical state of the interface:
•
DOWN (Administratively)—The interface was shut
down with the shutdown command, that is, is
administratively down.
•
DOWN—The interface is administratively up but
physically down.
•
UP—The interface is both administratively and
physically up.
Data link layer state (UP or DOWN).
Description string of the interface.
Maximum transmit unit (MTU) of the interface.
Interval at which the current interface sends keepalive
packets.
Primary IP address of the interface.
PPP negotiation includes the negotiation of multiple
protocols. The field indicates that the negotiation of LCP,
MP, and IPCP is complete.
Physical type and speed of the interface.
Time when statistics on the interface were last cleared.
Average input and output rate over the last 300 seconds.
Total number and size (in bytes) of the input packets of the
interface, and the number of dropped packets.
Total number and size (in bytes) of the output packets of the
interface, and the number of dropped packets.
Brief information about Layer 3 interfaces.
Link status:
•
ADM—The interface has been administratively shut
down. To recover its physical state, perform the undo
shutdown command.
•
Stby—The interface is operating as a backup interface.