Table of Contents
Advertisement
Description
Use the bundle min-active links command to set the minimum number of selected interfaces required to
bring up the HDLC link bundle.
Use the undo bundle min-active links command to remove the limit.
By default, no limit is set on the minimum number of selected member interfaces required to bring up an
HDLC link bundle.
The value specified by using this command cannot be bigger than that specified using the bundle
max-active links command.
Related commands: bundle max-active links.
Examples
# Set the number of selected member interfaces required to bring up HDLC link bundle 1 to 5.
<Sysname> system-view
[Sysname] interface Hdlc-bundle 1
[Sysname-Hdlc-bundle1] bundle min-active links 5
default
Syntax
default
View
HDLC bundle interface view
Default level
2: System level
Parameters
None
Description
Use the default command to restore the default settings for an HDLC bundle interface.
This command might fail to restore the default settings for some commands for reasons such as command
dependencies and system restrictions. You can use the display this command in interface view to check
for these commands, and perform their undo forms or follow the command reference to individually
restore their default settings. If your restoration attempt still fails, follow the error message to resolve the
problem.
CAUTION:
The default command might interrupt ongoing network services. Make sure you are fully aware of the
impacts of this command when you perform it on a live network.
Examples
# Restore the default settings for HDLC link bundle interface 1.
<Sysname> system-view
[Sysname] interface Hdlc-bundle 1
[Sysname-Hdlc-bundle1] default
This command will restore the default settings. Continue? [Y/N]:y
54
Advertisement
Table of Contents
