Oam Cc End-To-End - H3C SR8800 Command Reference Manual

View
ATM interface view
Default level
2: System level
Parameters
mtu-number: MTU size in bytes on the current ATM interface, in the range of 128 to 2000.
Description
Use the mtu command to set the size of maximum transmission unit (MTU) on the current ATM interface.
Use the undo mtu command to restore the default.
By default, the MTU of an ATM interface is 1500 bytes.
NOTE:
You can configure this command in either ATM main interface view or ATM subinterface view. The
command takes effect only on the configured interface or subinterface.
Examples
# Set the MTU to 1492 bytes for interface ATM 3/1/1.
<Sysname> system-view
[Sysname] interface Atm 3/1/1
[Sysname-Atm3/1/1] mtu 1492

oam cc end-to-end

Syntax
oam cc end-to-end { both | sink | source }
undo oam cc end-to-end { both | sink | source }
View
PVC view
Default level
2: System level
Parameters
both: Enables the PVC as both the continuity check (CC) cell source and the CC cell sink, that is, the
receiver.
sink: Enables the PVC as the CC cell sink to receive and process CC cells.
source: Enables the PVC as the CC cell source to generate CC cells.
Description
Use the oam cc end-to-end command to enable the OAM continuity check (CC) function on the current
PVC.
Use the undo oam cc end-to-end command to disable the OAM CC function on the current PVC.
By default, OAM CC is disabled.
16