Replacing The Waste Ink Tank Before The Waste Ink Tank Confirmation Message Is Displayed; Replacing The Cutter Blade - MIMAKI JV300-130 A Operation Manual

Chapter 4 Maintenance
Replacing the waste ink tank before the waste
ink tank confirmation message is displayed
if you replace the waste ink tank before the waste ink tank
confirmation message is displayed (before the 2L tank is
80% (1.6L) full), set the waste ink information to 0% in the
Information menu.
Perform steps 6 through 9 in "Replace the
1
waste ink tank with another" (
empty the waste ink tank.
Press the
2
key in LOCAL.
• MAINTENANCE MENU will be displayed.
Press 4 times, and press the Press
3
the
• "INK TANK EXGHANGE" will be selected.
Waste ink tank information is displayed.
4
Press
5
press the
• The reset screen for the waste ink tank amount
will be displayed.
Press the
6
• The waste ink tank amount that is managed in this
machine will be reset.

Replacing the Cutter Blade

The cutter blade is consumable.When the cutter blade
gets dull, replace it with a new one (SPA-0107).
• Do not touch the cutter blade, which is very sharp.
• Store the cutter blade in a place that is out of the
reach of children.In addition, dispose of used
cutter blades according to regional laws and
regulations.
• When replacing the cutter blade, it is
recommended to place a sheet of paper under the
cutter blade. This will help pick up the cutter blade
if it drops.
Press the
1
key in LOCAL.
• MAINTENANCE MENU will be displayed.
Press the
2
the front cover.
• The carriage moves onto the platen.
4-16
P.4-15) to
(MENU)
key.
to adjust the level, and
key.
key.
(MENU)
key twice, and open
Carriage
Replace the cutter unit by the carriage.
3
(1) Loosen the screw of the cutter unit.
(2) Remove the cutter unit.
(3) Mount a new cutter unit.
(4) Fasten the screw of the cutter unit to secure
the cutter unit.
Screw
Close the FRONT cover.
4
Press the
5
Cutter unit
key.