Automatic Measurement In Harmonic Analysis Mode - AEMC OX III Series User Manual

Applications (cont'd)
9. Automatic
measurement in
Harmonic Analysis
mode
Recall
Shop for AEMC products online at:
IX - 178
Initially, there must be one or two traces on channels CH1 to CH4.
- Only the channels (and not the functions) can be the subject of
harmonic analysis.
- In this mode, the time base is not adjustable.
•
Set the traces for channels CH1 to CH4 to the mode "Oscilloscope".
•
Using the key opposite, select the "Harmonic Analysis" mode.
The traces of channels CH1 and CH4 are shown in a dark color, while the
traces of CH2 and CH3 are light (or in the color of the trace).
•
Use the "Display" menu (see §. Display) to select the
harmonic breakdown required:
- the fundamental (F) and the first 15 harmonics
- the even harmonics (2 to 30)
- the odd harmonics (3 to 31)
The selection chosen appears under the breakdown display.
The "SIGNAL" table under the breakdown provides information on:
•
- the active channel(s) (CH1 to CH4)
- the RMS voltage of the signal in V
- harmonic distortion rate (in %) of the signal
The " " symbol, present on the fundamental (F) or one of the
•
harmonics and modifiable using the stylus, means that measurements
can be made on the harmonic selected.
ShopAEMC
www. .com 1.877.766.5412
Applications
SCOPIX