Table of Contents
Advertisement
Oscilloscope Mode (cont'd)
I/O port config
USB
RS232
Speed
Format
Parity
Stop bits
Protocol
Shop for AEMC products online at:
IV - 94
In the "USB / RS232" window, check the USB Cable button.
This interface uses the (USB / RS232 / ETHERNET) connector on the right
side of the equipment. The HX0084 cable must be used.
The HX0084 cable converts the RS232 format output from the instrument to
the USB protocol. After installation of the driver supplied on the CD on the
host PC, communications with the instrument can be made using a "Virtual
Com Port" (VCP).
Take care to configure the Virtual Com Port on the host PC as follows:
Bits per second
Data Bits
Parity
Stop Bits
Flow control
In the "USB / RS232" window, do not check the USB Cable button.
This interface uses the (USB / RS232 / ETHERNET) connector on the right
side of the equipment. The USB / RS 232 adapter (HX0084) or HX0042
RS232 / SUBD9 cable must be used.
Transmission speed:
Word length:
Parity:
Number of stop bits:
Serial link management mode:
Hard Hardware: the protocol is provided by the RTS and CTS lines
of the RS232 link.
Software: use of the XON and XOFF characters to synchronize
Soft
transmission and reception of the messages (reduced "3-wire" link)
None No protocol checking
• The «
» symbol indicates the selected option.
• The option can be modified using the stylus.
ShopAEMC
www.
Oscilloscope Mode - The "Utilities" Menu
460800
8 bits
None
1
Hardware
300 to 115,200 Bauds.
7 or 8 bits.
even, odd or no parity (none).
1 or 2 stop bits
.com
1.877.766.5412
SCOPIX
Advertisement
Table of Contents
