Measurement In Multimeter Mode - AEMC OX III Series User Manual

Applications
Applications (cont'd)
12. Measurement in
multimeter mode
Measurement in
Multimeter Mode
Shop for AEMC products online at:
SCOPIX
• Press the key opposite to activate the "Multimeter" mode.
• Connect the Probix HX0033 adapter on the CH1 input.
A message indicating the characteristics of the probe is displayed
briefly, confirming that it has been detected.
The positive input is indicated by the "+" sign on the adapter for V
measurements.
• Use the appropriate cables to connect the Probix adapter to the test
resistor.
• Select input CH1 in Ohmmeter mode:
Menu: Measurement
Ohmmeter mode (Ω) is indicated in the display of the parameters for
CH1.
• Validate the measurements on CH1 by pressing the key opposite (- X -
disappears).
The resistance measured is not known:
• Select the "Autorange" mode.
"Channel 1 Parameters" menu under Vert
or by a long press on the CH1 key.
The autorange mode (auto) is indicated in the display of the parameters
for CH1.
In this case, the instrument constantly seeks the most suitable
measurement range.
The resistance measured is known:
• Select the appropriate range:
"Channel 1 Parameters" menu under Vert
or using the keys opposite.
See the general characteristics for the ranges available.
• Select the "Statistics" mode.
Menu: Display Statistics, to find out the minimum and
maximum values when the measurement variations are analyzed.
The MIN and MAX measurements are indicated in the display of the
parameters for CH1.
• Use the keys opposite to select the duration of the period
(5', 15', 30', 1 h, 6 h, 12 h, 24 h, week, month) for analysis of the
measurement variations.
The duration selected is indicated in the top left-hand corner of the
graphic window.
• Deactivate "Roll" mode:
Menu: Horiz Roll to stop the measurements at the end of the
analysis period.
ShopAEMC
www.
CH1 Ohmmeter.
CH1
CH1
.com 1.877.766.5412
DC
Range/Coupling
Range/Coupling
IX - 183