Table of Contents
Advertisement
Oscilloscope Mode - The "Utilities" Menu
Oscilloscope Mode (cont'd)
Network
provided by a
DHCP server
Physical address
IP address
Printer (or Ipd server):
IP address
Shop for AEMC products online at:
SCOPIX
Configuration of the ETHERNET parameters
If this box is checked, the instrument makes a request to the network
DHCP server to automatically obtain:
•
an IP address
•
a subnet mask
•
the gateway address
•
possibly a network printer IP address
When powering up, if you activated this protocol during a previous
session, a confirmation is requested before sending the DHCP
request via ETHERNET.
If the instrument is no longer connected to the network, answer "no"
to the question, otherwise it will wait several minutes for an answer
from the DHCP server, before becoming functional.
Oscilloscope address on the ETHERNET network.
This address cannot be modified (it is specific to the instrument)
Example: 00-01-02-03-04-63
Oscilloscope IP address on the ETHERNET network.
This address can be input automatically or manually with the keyboard,
after selecting the zone to be modified.
The
key can be used to delete the value preceding the cursor in the
zone to be modified.
An IP address can be assigned automatically by a DHCP server, if the
server is accessible, by ticking the box "provided by a DHCP server".
Example: 132.147.200.74
After modification, the IP address is displayed for 30' at the bottom right of
the screen.
IP address of the printer or a PC where the printer is connected. In this
case, an "LPD Server" programme must be installed on the PC.
This address must be input manually with the keyboard, after selecting the
zone to be modified.
The
key can be used to delete the value preceding the cursor in the
zone to be modified.
Example: 132.147.240.1
ShopAEMC
www.
.com
1.877.766.5412
IV - 95
Advertisement
Table of Contents
