AEMC OX III Series User Manual page 45

Oscilloscope Mode - The Keys
Oscilloscope Mode (cont'd)
Definition of terms
used
5 "VERTICAL" keys
or key pads
OX 7204
OX 7202
Shop for AEMC products online at:
SCOPIX
Validated channel:
Displayed channel:
Selected channel:
Step 1
Before pressing one of the
III
following keys :
The channel concerned is
not displayed.
The channel concerned is
displayed, but not selected.
The channel concerned is
displayed and selected.
III
Step 1
Before pressing one of the
following keys :
The channel concerned is
not displayed.
The channel concerned is
displayed, but not selected.
The channel concerned is
displayed and selected.
A long press on one of the keys CHx causes a vertical autoset:
• This modifies the sensitivity and vertical positioning of the channel in
question.
• It optimizes the display on the screen by activating and selecting the
channel.
The channel is displayed and selected.
www.
Display enabled, trace displayed after RUN
Channel validated, trace present on the screen
The parameters of this channel can be set with the keys:
Step 2
Press
Step 2
Press
ShopAEMC
and
Step 3
After pressing one of the
preceding keys:
The channel is displayed and
selected.
The vertical sensitivity and
vertical position are assigned
to the channel selected.
The channel is selected.
The channel is cancelled by
double-pressing.
Step 3
After pressing one of the
preceding keys:
The channel is displayed and
selected.
On CH1 and CH4, the vertical
sensitivity and the vertical
position are assigned to the
channel selected.
The channel is selected.
The channel is cancelled by
double-pressing.
.com 1.877.766.5412
IV - 45