AEMC OX III Series User Manual page 130

Recorder Mode (cont'd)
5 "VERTICAL" keys
(or keypads)
OX 7xx4
OX 7xx2
or
Shop for AEMC products online at:
VII - 130
Stage 1
Before pressing one of the
keys shown opposite:
The signal concerned is not
displayed.
The signal concerned is
displayed but not selected.
The signal concerned is
displayed and selected.
Stage 1
Before pressing one of the
keys shown opposite:
The signal concerned is not
displayed.
The signal concerned is
displayed, but not selected.
The signal concerned is
displayed and selected.
Deselecting the signal: 2 short taps on the key concerned (see opposite).
A long press does not trigger a vertical autoset. After a long press the
message: "Impossible in this mode!" appears.
This key enables or disables the horizontal dividing into 2 parts of the
display area (see "Oscilloscope" mode).
No action.
(Pressing the key displays the message: "Impossible in this mode!").
In "Recorder" mode, the DC input coupling is constant. The DC symbol
is permanently displayed.
To set the vertical sensitivity of the last channel selected (see "Oscilloscope"
mode).
To set the vertical position of the last channel selected (see "Oscilloscope"
mode).
ShopAEMC
www.
Stage 2
After pressing one of these
Press
keys:
The signal is displayed and
selected.
The vertical sensitivity and
vertical position are allocated
to the selected channel.
The signal is erased by
double pressing.
Stage 2
After pressing one of these
Press
keys:
The signal is displayed and is
selected.
On CH1 and CH4, the vertical
sensitivity and vertical position
are allocated to the selected
channel.
The signal is erased by
double pressing.
.com 1.877.766.5412
Recorder Mode - Keys
Stage 3
Stage 3
SCOPIX