AEMC OX III Series User Manual page 23

Micro SD Memory Card
Micro SD Memory Card
Introduction
Installation
Location
Insertion/Extraction
Operation
Recording
a file
Shop for AEMC products online at:
SCOPIX
The internal memory of the oscilloscope (2MB) may be extended by using
an SD Card (128MB - 2GB).
The oscilloscope accepts the Micro-SD format (but not Micro-SDHC).
FAT32 format is not compatible with the oscilloscope.
The SD Card compartment is located on the right-hand side of the
oscilloscope near the communications interface connector.
- Insert the SD Card, in the card compartment, printed surface facing up.
- Push to the click
- To remove the card, press slightly on the card itself and support it while
removing.
• The filename is limited to a maximum of 20 characters + extension.
If this rule is not observed, the message: 'Filename too long' is displayed.
• If the name already exists or is incompatible, an error message
'Impossible! File already exists' will be displayed.
• By moving the pointer
characteristics displayed (date and time saved and size).
ShopAEMC
www.
the card is in position.
onto the names of the files, you will see their
.com 1.877.766.5412
II - 23