AEMC OX III Series User Manual page 206

Technical Specifications (cont'd)
Oscilloscope Mode
Display
Characteristics
Display screen
Light
Resolution
Screen saver
Display modes
All acquisition
Graticule
Indications on screen
Triggering
Miscellaneous
1/10th probe calibration signal
Autoset
Search time
Frequency range
Range of amplitude
Cyclic ratio limits
Shop for AEMC products online at:
X - 206
1/4 VGA, i.e. 320 pixels horizontally x 240 pixels vertically
Delay can be selected in the Util Menu
Vector Acquired samples, interpolated samples, averaging, linear interpolation
between 2 acquired samples.
Envelope Display of min. and max. on each abscissa, acquired in several bursts
Averaging Range of factors: none, 2, 4, 16, 64
Display of all the samples acquired in a burst with linear interpolation
Trigger level position (with coupling and overshoot indicator)
Position of the Trigger point on the bargraph and on the top edge of the
screen (with overshoot indicators)
Traces Trace identifiers, activation of the traces
Position, Sensitivity
Ground reference
High and low overshoot indicators if traces are off screen
Dual insulation / channels: 600V CAT III, 1000V CAT II
Connect the cold point of the probe to the cold point of the
www.
OX 7102
OX 7202
LCD 5.7'' TFT (color display)
LED back-lighting
Continuous adjustment
15', 30', 1 hour or none
Complete or Edges
Form: rectangular
Amplitude: ≈ 0- 3 V
Frequency: ≈ 1kHz
probe calibration output.
> 30 Hz
15 mVpp to 400 Vpp
from 20 to 80 %
ShopAEMC
Technical Specifications
III III
- OX 7104
III III
- OX 7204
Configuration
< 5 s
.com 1.877.766.5412
SCOPIX