Table of Contents
Advertisement
Multimeter Mode - The "Measure" Menu
Multimeter Mode (cont'd)
The "Measure" Menu
Reference
ch1: Amplitude
ch1: Ohmmeter
ch1: Continuity
ch1: Capacimeter
ch1: Component Test
ch1: PT100
Shop for AEMC products online at:
SCOPIX
The reference is used to select the measurement trace on which the cursor is
positioned. The cursor value is therefore relative to the measurement on this
channel.
It is only possible to choose the reference on activated channels: channels
that are not activated are displayed in a lighter colour in the sub-menu.
The "
" symbol indicates the reference selected.
Channel CH1 is used as a voltmeter and therefore measures the amplitude of
the signal present on the input of this channel.
Channel CH1 is used as an ohmmeter and therefore measures the resistance
of the dipole wired to the input.
Channel CH1 is used as a continuity tester: there is a beep if the input
resistance is less than ≈ 30 Ohms.
In this mode, measurements are impossible on the other channels.
Channel CH1 is used as a capacitance meter and therefore measures the
capacitance of the dipole wired to the channel's input.
In this mode, measurements are impossible on the other channels.
Channel CH1 is used as a component tester. This mode measures the
threshold of the diode wired to the input.
In this mode, measurements are impossible on the other channels.
These configurations measure a temperature using a 100 Ω (PT100) resistive
sensor.
ShopAEMC
www.
Do not use HX0030 probe for
following measurements :
-
Ohmmeter
-
Continuity
-
Capacimeter
-
Test Component
.com
1.877.766.5412
V - 113
Advertisement
Table of Contents
