KidKraft Cedar Summit Adventure Ridge Playset Installation And Operating Instructions Manual page 95

Step 48: Attach Ground Stakes
A: In the 2 places shown in fig. 48.1 drive the Rebar Ground Stakes 13" into
the ground. Be careful not to hit the washer while hammering stakes into the
ground as this could cause the washer to break off.
B: Attach Ground Stakes using 1 (S7) Pan Screw per Ground Stake
(Fig. 48.2).
C: After driving stakes into the ground, check for sharp edges caused by
the impact of the hammer. Smooth any sharp edges from impact area and
touch up with outdoor paint.
Warning!
stakes must be driven 13" into ground. Digging or driving stakes
can be dangerous if you do not check first for under-ground
Fig. 48.1
Hardware
2 x #12 x 2" Pan Screw
S7
95
To prevent tipping and avoid potential injury,
wiring, cables or gas lines.
S7
Fig. 48.2
13"
Other
2 x Rebar Ground Stake