KidKraft Cedar Summit Adventure Ridge Playset Installation And Operating Instructions Manual page 88

Step 42: Build Tunnel Assembly
Part 1
A: Bend all 6 MOD Tunnel Panels as shown in fig. 42.1
B: Match 2 MOD Tunnel Panels together by making a slight "V" with the pieces so the peak of the "V" faces away
from you. Make sure connector tabs are coupled then straighten the 2 panels. Push down on one panel and up on
the other until you hear the connector tabs click together and the bottom edges are flush. You may have to knock
panels on a hard surface to align properly. Do this so there are 3 MOD Tunnel Panels attached together.(fig. 42.2
and 42.3)
C: Press nodules through the connector tab holes to hold Tunnel panels in
place. (fig. 42.3)
D: Repeat Steps B-C to create two Tunnel Sides.
Fig. 42.2
Inside View
Outside View
bend here
MOD
Tunnel
Panel
nodule
88
Fig. 42.3
connector tab
Other Parts
6 x MOD Tunnel Panel