KidKraft Cedar Summit Adventure Ridge Playset Installation And Operating Instructions Manual page 23

Step 4: Join Swing and Slide Wall Assemblies
Part 2
C: From inside the assembly, tight to both (022) Slide End Panel and (032) SW Wall Panel, halfway up the assembly,
5/8" below the panel, loosely attach 1 (043) Side Joist to (021) Narrow Back Panel and (033) Back Rock Panel with 3
(WB10) 5/16 x 2-5/8" Wafer Bolts (with flat washer and t-nut). Bolts are installed from inside the assembly. Make sure
(043) Side Joist is level then attach with 2 (S3) #8 x 2-1/2" Wood Screws and tighten bolts. (fig. 4.4 & 4.5 & 4.6)
D: Repeat Step C to attach 1 (043) Side Joist to (023) Narrow Front Panel and (031) Front Wall Panel. (fig. 4.5 & 4.6 )
021
Fig. 4.6
022
023
Fig. 4.5
Inside View
Tight
S3
Wood Parts
2 x Side Joist 2 x 2 x 63"
043
033
5/16"
T-Nut
Hardware
4 x #8 x 2-1/2" Wood Screw
S3
6 x 5/16 x 2-5/8" Wafer Bolt
WB10
(5/16" flat washer, 5/16" t-nut)
043
Fig. 4.4
032
031
043
5/16" Flat
Washer
WB10
23
5/8"
061
Tight
043
S3
Panel