KidKraft Cedar Summit Adventure Ridge Playset Installation And Operating Instructions Manual page 31

Step 7: Attach Diagonals
Part 2
D: Loosely attach (073) Support Diagonal to (074) Diagonal with 1 (WB9) 5/16 x 2-1/8" Wafer Bolt (with flat
washer and t-nut) then place (072) Diagonal tight and flush to the front of (033) Back Rock Panel. The (073)
Support Diagonal should be flush to the bottom of (032) SW Wall Panel.(fig. 7.3 & 7.4)
E: Pre-drill pilot hole with a 3/16" drill bit then attach (072) Diagonal to (033) Back Rock Panel with 1 (WL5) 1/4 x
2-1/2" Wafer Lag (with flat washer), checking that it remains flush to outside edge. (fig. 7.3 & 7.4)
F: Make sure bottom of (073) Support Diagonal is flush to bottom of (032) SW Wall Panel then attach with 2
(S11) #8 x 2" Wood Screws and 1 (S4) #8 x 3" Wood Screw then tighten the bolt. (fig. 7.3 & 7.4)
Fig. 7.3
Front Wall
Wood Parts
1 x Diagonal 2 x 3 x 42¼"
074
1 x Diagonal 1-1/4 x 3 x 22"
073
SW Wall
Hardware
1 x 5/16 x 2-1/8" Wafer Bolt (5/16" flat washer, 5/16" t-nut)
WB9
1 x 1/4 x 2-1/2" Wafer Lag (5/16" flat washer)
WL5
1 x #8 x 3" Wood Screw
S4
2 x #8 x 2" Wood Screw
S11
31
Fig. 7.4
5/16" Flat
Washer
Flush
032
S11
S4
Flush
073
WL5
033
074
5/16"
T-Nut
5/16" Flat
WB9 Washer