KidKraft Cedar Summit Adventure Ridge Playset Installation And Operating Instructions Manual page 73

Step 30: Attach TNR 3 Slide to Fort
A: On the fourth attached Elbow Assembly remove the pan bolt and nut which is facing the fort (installed in Step 24).
(fig. 30.1) The bolt will no longer be needed, but keep the lock nut.
B: Loosely attach TNR3 Tube Support (at the slightly bent end) to the slide seam using 1 (PB6) 1/4 x 1" Pan Bolt (with
flat washer and the previously removed lock nut). (fig. 30.2)
C: Rotate TNR3 Tube Support and attach to (022) Slide End Panel using 1 (S6) #12 x 1" Pan Screw as shown in (fig.
30.2).
D: Fully tighten screw and bolt.
Fig. 30.2
TNR 3 Tube
Support
022
Note: Flat
end down
Lock
Nut
S6
Remove PB1 (1/4 x 3/4"
Pan Bolt) first then install
PB6 (1/4 x 1" Pan Bolt
with flat washer)
1 x #12 x 1" Pan Screw
S6
1 x 1/4 x 1" Pan Bolt
PB6
(1/4" flat washer & 1/4" lock nut - previously removed)
Fig. 30.1
Flat
Washer
PB6
022
Hardware
73
TNR Brace
Assembly
Other Parts
1 x TNR3 Tube Support
A