KidKraft Cedar Summit Adventure Ridge Playset Installation And Operating Instructions Manual page 75

Step 32: Attach Elbow Assemblies and TNR4 Slide
A: Place TNR Brace centered over pilot holes of (312) AL/RW Ground Brace. Attach with 3 (S4) #8 x 3 Wood Screws. (fig.
32.3)
B: Place 1 TNR4 Post Mount Clamp on either side of the Clamp Ring so that the bent tops clip in behind the Clamp Ring.
(fig. 32.2)
C: Insert the TNR4 Post Mount Base in between the 2 Post Mount Clamps and screw all pieces together using 1 ¼ x
14.5mm Pan Head Bolt and Square Nylock Nut. (fig. 32.2)
D: Attach TNR4 Post Mount Base to (311) TNR Upright, pre-drill with a 1/8" drill bit then attach with 2 (S6) #12 x 1" Pan
Screws. (fig. 32.2)
E: Attach the Post Mount Clamp to the clamp ring using 1 (S37) #7 x 5/8" Pan Screw. (fig. 32.2)
Fig. 32.1
A
2 x
3 x
1 x
S37
Fig. 32.2
S37
¼ x 14.5mm
Pan Head Bolt
TNR4 Post
Mount Base
S6
Fig. 32.3
S4
Hardware
#12 x 1" Pan Screw
S6
#8 x 3" Wood Screw
S4
#7 x 5/8" Pan Screw
75
TNR4 Post
Mount Clamp
Square
Lock
Nut
100
311
312
Other Parts
2 x TNR4 Post Mount Clamp
1 x TNR 4 Post Mount Base
1 x 1/4 x 14.5 mm Pan Head Bolt
1 x Square Lock Nut